Viper 700 ESP Installation Manual page 15

an output as long as the transmission continues. This output can be used to operate a trunk/hatch release or
other relay-driven function.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-
torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other
high-current device will cause it to fail.
H2/9 200 mA (-) channel 3 output
This wire provides a (-) 200 mA output whenever the remote button(s) controlling channel three is pressed. This
output can be programmed to provide the following types of output (see System Features Learn Routine section):
I Validity: Output that will send a signal as long as the transmission is received.
I Latched: Output that will send a signal when the Channel 3 button(s) is pressed and will continue until the
same button(s) is pressed again.
I Latched, reset with ignition: Similar to the latched output, this type of output turns on the first time the
Channel 3 button(s) is pressed and turns off the next time the same button is pressed. This type of output
additionally stops and resets whenever the ignition is turned on and then off.
I 30-second timed: Output that will send a continuous signal for 30 seconds. This output can be shut off
during the 30-second period by pressing the Channel 3 button again.
I Second unlock: This output can also be programmed to provide a second unlock pulse when the disarm
button is pressed within 15 seconds after disarming the system. This can be used to unlock the passenger
doors when installing progressive door locks.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! The transis-
torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other
high-current device will cause it to fail.
H2/10 normally closed interrupt output #1
Refer to the H2/7 wiring description.
© 2000 Directed Electronics, Inc. Vista, CA
(+) Positive Trunk Release Circuit
15