Table of Contents
Advertisement
6. Once you are certain that all connections have been made properly, restore the power.
3.4 DIN rail mounting and removal
The SL-MOD-GW gateway is designed to be mounted on a 35 mm DIN rail according to DIN/EN 50022. The
enclosure features a 35 mm profile at the back which snaps into the DIN rail. No tools are required for mounting.
Please observe the rules outlined in Section 3.5, "Mounting rules".
1
DIN rail
2
Click
Slide down
1
3.5 Mounting rules
The enclosure provides protection against solid objects according to IP 20 / NEMA Type 1 protection rating.
When mounting the unit observe the following rules:
• No water splash and water drops
• No aggressive gas, steam or liquids
• Avoid dusty environments.
• Avoid shock or vibration
• Do not exceed the specified operational temperatures and humidity range.
• Mount inside an electrical switchboard or control cabinet.
• Make sure there is sufficient air ventilation and clearance to other devices mounted next to the
unit.
• Observe applicable local regulations like EN60204 / VDE0113.
6
To mount the unit on a DIN rail, slot the top part of the
SL-MOD-GW into the upper guide of the rail and lower the enclo-
sure until the bottom of the red hook clicks into place.
To remove the SL-MOD-GW from the DIN rail, use a screw driver
as a lever by inserting it in the small slot of the red hook and push
the red hook downwards. Then remove the unit from the rail by
raising the bottom front edge of the enclosure.
2
UMSLMODGW-1006
Advertisement
Table of Contents
