Installation; Regulatory Notes; Unpacking, Handling And Storage; Before Connecting Anything - Weidmuller SL-MOD-GW User Manual

Modbus/tcp to modbus rtu gateway

Table of Contents

3. Installation

1. The SL-MOD-GW is suitable for use in non-hazardous locations only.

2. The SL-MOD-GW is not authorized for use in life support devices or systems.

3. Wiring and installation must be in accordance with applicable electrical codes in accordance

with the authority having jurisdiction.

4. This is a Class A device and intended for commercial or industrial use. This equipment may

cause radio interference if used in a residential area; in this case it is the operator's responsibility

to take appropriate measures.

5. The precondition for compliance with EMC limit values is strict adherence to the guidelines

specified in this set of instructions. This applies in particular to the area of grounding and

shielding of cables.

FCC Notice (USA only)

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his own expense.

Industry Canada Notice (Canada only)

This Class A digital apparatus complies with Canadian ICES-003.

1. Please read this set of instructions. carefully before fitting it into your system.

2. Keep all original packaging material for future storage or warranty shipments of the unit.

3. Do not exceed the specified temperatures.

1. Before installing or removing the unit or any connector, ensure that the system power and

external supplies have been turned off.

2. Check the system supply voltage with a multimeter for correct voltage range and polarity.

3. Connect the power supply cable and switch on the system power. Check if the Power LED is lit.

4. Turn off system power.

5. Connect all I/O cables.

UMSLMODGW-1006

Table of Contents