Advertisement
CONFIGURING SUV SYSTEM 120VAC/240VAC
Input Voltage (120VAC/240VAC Convertible Pack)
This Power System is supplied to utilize a 240V power supply (2 hot wires, a neutral wire, and a ground wire). If
conversion to 120V is required, a jumper wire supplied with the system must be installed between J-16 and J35. Also, dip
switch #10 must be set to the "On" position. A 120V power supply (1 hot wire, 1 neutral wire, and a ground wire) can
then be hard wired to the power input terminal block labeled TB1. Attach the black wire to the terminal marked "Black,"
the white wire to the terminal marked "White," and the green wire to the terminal marked "Ground." See conversion
instructions on the wire schematic attached to the back of the power system enclosure cover.
When configured to operate at 120V, the heater is rated at 1.5kW and will heat only during Pump 1 low operation. When
configured to operate at 240V, the heater is rated at 4.0kW and will heat whenever heat is required.
120V Input Voltage
J16
TB1
WHT
BLK
GRN
J35
Dip Switches
*Jumper wire attached to rear of power system enclosure
When configuring the output voltages on the Fantasy SUV System, remember to also consider the amperage of
each component. Be sure that the total amperage draw does not exceed the capability of the circuit supply and
power to the system.
Output Voltage for all pumps is 120VAC on domestic units.
NOTE:
Your spa has been configured with three operational modes. Your spa has been pre-programmed
with a default of Standard Mode. To change your spas operational mode dip switch #7 on the power
supply board must be moved down into the "off" position. See additional instructions to change
operational mode on Page 10.
Printed Circuit Board Layout
WHT
BLK
RED
GRN
Jumper Wire*
ON
240V Input Voltage
Dip Switches
NOTE: All components are 120 volt- motors and ozone units.
Blowers are not provided. Do not covert on circuit board for
individual components.
9
OFF
Hide quick links:
Advertisement
