A Good Foundation; Placing The Hot Tub - Fantasy Spas ILLUSION Owner's Manual

Your new hot tub needs a good solid foundation. The area your hot tub sits on must be able to
support the tub, the water in it and those who use it. If the foundation is inadequate, it may
shift or settle after the hot tub is in place, causing stress to the shell or components.
BE AWARE:
Damage caused by inadequate or improper foundation support is not covered by the hot tub
warranty. It is the sole responsibility of the hot tub owner to provide a proper foundation for
the hot tub.
Make sure the foundation where the hot tub is placed drains water away from the hot tub.
Proper drainage will keep components dry from rain and wet weather.
If you choose to install your hot tub indoors, pay close attention to the flooring beneath it.
Always remember a hot tub is filled with water. Choose flooring that will not be spoiled or
ruined from water damage. Check with your contractor to verify your flooring can support the
weight and water spills or splashing from your hot tub.
Your hot tub weight must always be considered when installing your hot tub. If you are
installing it on an elevated wood deck or other structure, it is advisable to consult a structural
engineer or contractor to ensure the structure will support the weight.
IT IS STRONGLY RECOMMENDED THAT A QUALIFIED, LICENSED
CONTRACTOR PREPARE THE FOUNDATION FOR YOUR HOT TUB.
There is a 4" (10cm) minimum depth requirement for a concrete pad.
CHECK THE DIMENSIONS OF YOUR HOT TUB
Compare the hot tub dimensions to the width of gates, sidewalks, and doorways along the
delivery route used to bring the hot tub into your yard. It may be necessary for you to remove
a gate or partially remove a fence in order to provide an unobstructed passageway to the
installation location.
Also, keep in mind—if you are using special equipment to place your hot tub into an area it
will be necessary to include those measurements and weights.
PLANNING A DELIVERY ROUTE:
Check the width of gates, doors and sidewalks to make sure your hot tub will pass through
unobstructed. You may need to remove a gate or part of a fence to allow for adequate width
clearance.
If the delivery route will require a 90 degree turn, check the measurements at the turn to ensure
the hot tub will fit.
Check for protruding gas meters, water meters, A/C units, etc., on your home which will cause
obstructions along the delivery path to your yard.
Check for low roof eaves, over hanging branches or rain gutters that could be an obstruction to
overhead clearances.
SPECIAL CIRCUMSTANCES
The use of a crane for delivery and installation is primarily to avoid injury to your hot tub, your
property or to delivery personnel. Your dealer may be able to assist you with the
arrangements. Cranes are not considered "normal delivery" and would need to be a specialty
request.

A Good Foundation

Placing the Hot Tub

5