Keating of chicago inc. gas hot plate service manual (13 pages)
Summary of Contents for Keating Of Chicago MG-2
Page 1
GAS HOT PLATE MG-2/MG-4 MANUAL IMPORTANT: THE USER'S MANUAL PROVIDES SPECIFIC OPERATING INSTRUCTIONS FOR YOUR MODEL. USE THE GAS HOT PLATE ONLY AS INSTRUCTED IN THIS MANUAL. KEEP A COPY OF YOUR BILL OF SALE. The date on the bill establishes the warranty period should service be required.
PURCHASER SHOULD POST IN A PROMINENT LOCATION INSTRUCTIONS TO BE FOLLOWED IN THE EVENT THE USER SMELLS GAS. THIS INFORMATION SHALL BE OBTAINED BY CON- SULTING THE LOCAL GAS SUPPLIER. WARNING Burns Shock Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or death.
GAS HOT PLATE TABLE OF CONTENTS Important Safety Instructions ..........i PLACING YOUR KEATING HOT PLATE IN OPERATION INTRODUCTION .............. 1 Lighting ..............4 - 5 INSTALLATION Shutdown ............... 5 Damage During Shipment ..........1 Cleaning ................. 5 Options ................2 PREVENTATIVE MAINTENANCE Standard Features ............
Keating MG-2 and MG-4 Hot Plates are designed to • No frame or restriction shall be constructed give maximum production effi ciency, delivering high around the hot plate that will restrict air quality food products. The following design features movement into the hot plate’s combustion area are incorporated in all Keating Hot Plates.
GAS HOT PLATE • NEVER introduce objects into hot plate, while operational, which are not designed or made for IF NOT INSTALLED, OPERATED AND MAINTAINED IN cooking. ACCORDANCE WITH THE MANUFACTURER’S IN- STRUCTIONS, THIS PRODUCT COULD EXPOSE YOU • THIS HOT PLATE MAY NOT BE ALTERED, MODIFIED TO SUBSTANCES IN FUEL OR IN FUEL COMBUSTION OR CHANGED IN ANY WAY.
GAS CONNECTION NOTE: For hot plates with optional spark ignitors, the electrical wiring diagram is located on the front of the control panel. Hot plates with constant pilots do not require any electrical connections. • PIPE JOINT COMPOUNDS RESISTANT TO PROPANE GASES MUST BE USED.
Keating’s warranty begins with the date of installation. In the event that your Hot Plate, under warranty, needs repairs other than routine maintenance or clean- ing, you are required to contact Keating of Chicago (at 1-800-KEATING) before calling a local service company.
SERVICE DIAGNOSIS On constant pilot models, the pilot light will be between 3/8" to 1/2" high and burn clear blue. The constant pilot consumes about 180 BTU/hr. of gas and is used to ignite the burners. The following diagnosis is only to be used as a guide to qualifi ed service personnel. Keating recommends that you use a qualifi...
PRESSURE REGULATOR NATURAL GAS 004236 PROPANE 023527 CORD WITH PLUG, 6', 16/3 SJO FOR SPARK IGNITOR WITH WIRING HARNESS FOR MG-2 CORD WITH PLUG ONLY 006315 WIRE HARNESS ONLY CONDUIT, 1/2" (SPECIFY FOR 24" OR 30" DEEP) BUSHING, STRAIN RELIEF 000470 CONDUIT CONNECTOR, 1/2"...
HOT PLATE ASSEMBLY NOTE: MG-4 hot plates are built as two MG-2 hot plates side by side. The MG-2 is shown here. NOTE: Part numbers correspond with the Hot Plate Parts list on page 7. keatingofchicago.com...
The diagrams below apply to hot plates with spark ignition (“SI”). Hot plates with constant pilots (“CP”) do not have any electrical connections. NOTE: MG-4 hot plates are essentially two MG-2 hot plates side by side. Each cabinet half has its own spark module, electrode and ignitor switches.
CUSTOM PASTA FILTER SYSTEM TOP-SIDE COOKER HOTPLATE I HAVE READ THE INSTALLATION AND OPERATING INSTRUCTIONS. SIGNED: DATE: KEATING OF CHICAGO, INC. 1-800-KEATING 8901 West 50th Street PHONE: 708-246-3000 McCook, IL 60525-6001 FAX: 708-246-3100 Serving Those Who Serve the Very Best...