Keating Of Chicago Gas Hot Plate MG-2 Service Manual
Keating of chicago inc. gas hot plate service manual
Hide thumbs
Also See for Gas Hot Plate MG-2:
- User manual (15 pages) ,
- Manual (13 pages) ,
- Manual (16 pages)
Related Manuals for Keating Of Chicago Gas Hot Plate MG-2
Summary of Contents for Keating Of Chicago Gas Hot Plate MG-2
- Page 1 MG-2/MG-4 GAS HOT PLATE SERVICE MANUAL KEEP THIS MANUAL FOR TRAINING NEW PERSONNEL 1-800-KEATING www.keatingofchicago.com Hot Plate 0107 09/07...
-
Page 2: Table Of Contents
TABLE OF CONTENTS SECTION I INTRODUCTION General Information ......1 Ratings ........1 Options . - Page 3 POST THIS LABEL IN A PROMINENT LOCATION ON YOUR UNIT IN THE EVENT A GAS ODOR IS DETECTED, SHUT DOWN UNITS AT MAIN SHUT OFF VALVE AND CONTACT THE LOCAL GAS COMPANY OR GAS SUPPLIER FOR SERVICE. WARNING DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.
-
Page 4: General Information
I INTRODUCTION GENERAL Keating MG-2 and MG-4 Hot Plates are designed to give maximum production efficiency; delivering high quality food products. The following design features are incorporated in all Keating Hot Plates. STANDARD FEATURES Highly polished stainless steel front Infinite controls 12"... -
Page 5: Section Ii Installation
Panel added carbon monoxide to the list of hazardous chemicals known to cause reproductive harm. In order to establish full compliance with Proposition 65, we attached a yellow warning label to each gas fired hot plate manufactured by Keating of Chicago, Inc. Carbon monoxide would concentrations that would pose a “significant risk”... -
Page 6: Installation
testing at test pressures less than to equal to 1/2 psig (3.45 KPA), hot plate must be isolated from gas supply piping. When pressure testing at test pressures above 1/2 psig (3,45 KPA), hot plate must be disconnected from gas supply piping system. POSITIONING The hot plate must be no closer than 6"... -
Page 7: Section Iii Operating
Keating’s warranty begins with the date of installation. In the event that your hot plate, under warranty, needs repairs other than routine maintenance or cleaning, you are requested to contact Keating of Chicago (at 1-800- KEATING) before calling a local service company. PREVENTIVE MAINTENANCE... -
Page 8: Section V Service Diagnosis
V SERVICE DIAGNOSIS On constant pilot models, the pilot light will be between 3/8" to 1/2" high and burn clear blue. The constant pilot consumes about 180 BTU/hr. of gas and is used to ignite the burners. A. Trouble Shooting The following diagnosis is only to be used as a guide to qualified service personnel. -
Page 9: Hot Plate Parts List
GAS HOT PLATE PARTS LIST ITEM DESCRIPTION GAS VALVE (INFINITE CONTROL) WITH NG ORIFICE #49 CONSTANT PILOT SPARK IGNITOR ORIFICE, HOODED, NATURAL GAS, #49 GAS VALVE (INFINITE CONTROL) WITH PROPANE ORIFICE #53 CONSTANT PILOT SPARK IGNITOR ORIFICE, HOODED, PROPANE, #53 KNOB, RED, GAS VALVE CONSTANT PILOT VALVE CONSTANT PILOT ASSEMBLY WITH ORIFICE... -
Page 10: Hot Plate Assembly
HOT PLATE ASSEMBLY NOTE: MG-4 hot plates are built as two MG-2 hot plates side by side. The MG-2 is shown here. NOTE: Part numbers correspond with the Hot Plate Parts list on page 9. -
Page 11: Section Vii Wiring Diagrams
VIII WIRING DIAGRAMS MG SI WIRING AND LADDER DIAGRAMS The diagrams below apply to hot plates with spark ignition (“SI”). Hot plates with constant pilots (“CP”) do not have any electrical connections. NOTE: MG-4 hot plates are essentially two MG-2 hot plates side by side. Each cabinet half has its own spark module, electrode and ignitor switches. - Page 13 I HAVE READ THE INSTALLATION AND OPERATION INSTRUCTIONS. I HAVE READ THE INSTALLATION AND OPERATION INSTRUCTIONS. SIGNED: ________________________________________________________________ DATE: SIGNED: ________________________________________________________________ DATE: SERVICE INFORMATION KEATING OF CHICAGO, INC. Phone: (708) 246-3000 FAX: (708) 246-3100 www.keatingofchicago.com KEATING LIMITED WARRANTY CARD KEATING LIMITED WARRANTY CARD...