Caring For The Key Fob; Type Approval - Fisker Karma 2012 Owner's Handbook Manual

Locking and Unlocking the Vehicle
REPLACING THE KEY FOB
BATTERY
If the vehicle detects that the key fob
battery is low an indicator light will
illuminate on the instrument cluster. Please
change the key fob battery as soon as
possible.
To change the key fob battery:
1. Place the key fob button side down on a
soft surface.
2. Using a small flat bladed tool, carefully
release the rear cover from the key fob.
3. Remove the rear cover.
4. Remove the battery.
5. Fit the new battery (type CR2032) with
the '+' side facing upwards. If possible,
avoid touching the flat surfaces of the
battery because finger marks will reduce
3.4
Locking and Unlocking the Vehicle
battery life. Wipe the battery clean
before fitting.
6. Re-assemble the two halves of the key
fob by aligning them and pressing them
together until they snap into place.
Used batteries must be disposed of
correctly, as they contain harmful
substances. Seek advice on disposal from
your local Fisker Retailer and/or your local
authority.

CARING FOR THE KEY FOB

CAUTION: The key fob contains
delicate electronic circuits and must
be protected from impact, water damage
and high temperatures. Avoid contact with
solvents, waxes and abrasive cleaners. Do
not leave the key fob exposed to direct
sunlight.

TYPE APPROVAL

Hereby, Fisker Automotive, declares that
this remote vehicle entry system is in
compliance with the essential requirements
and other relevant provisions of Directive
1999/5/EC.
The Declaration of Conformity can be
obtained by writing to:
Lear Corporation Wireless Department,
21557 Telegraph Road,
Southfield,
Michigan, 48033
USA.