Garage Door Opener; Homelink® Transmitter; Programming A Device - Fisker Karma 2012 Owner's Handbook Manual

Table of Contents

Advertisement

Garage Door Opener

HOMELINK® TRANSMITTER
Garage Door Opener
WARNING: Do not use this
HomeLink® transmitter with any
garage door that lacks safety stop and
reverse features. A garage door opener
which cannot detect an object in the path of
a closing door and then automatically stop
and reverse the door does not meet current
safety standards. Using a garage door
opener without these features increases the
risk of serious injury or death.
The HomeLink® universal
transmitter is built into the rear view
mirror and provides a convenient way to
replace up to three hand-held transmitters
with a single built-in device.

PROGRAMMING A DEVICE

WARNING: When programming your
HomeLink® transmitter, you will be
operating the garage door or gate. Be sure
that people and objects are out of the way,
to prevent potential harm or damage.
1. Make sure the vehicle is in Accessory
mode.
2. If you have previously programmed your
HomeLink® transmitter, proceed to step
3. Press and hold the two outer buttons
for approximately 20 seconds. When the
5.36
Garage Door Opener
indicator light (arrowed) begins to flash,
release the buttons. Do not hold the
buttons for longer than 30 seconds.
This initializes the HomeLink®
transmitter and erases previous settings
from all three channels.
Note: Do not perform this step when
programming additional hand-held
transmitters.
3. Decide which one of the three channels
you want to program.
4. Position the end of your hand-held
transmitter 1-3 inches (25 - 75 mm)
away from the buttons.
5. Simultaneously press and hold both the
mirror button you want to program and
hand-held transmitter button. The
indicator light will flash slowly and then
rapidly after the mirror successfully
receives the frequency signal from the
hand-held transmitter.
Release both buttons.
6. Press and hold the programmed garage
door opener button and observe the
indicator lamp.
• If the indicator is continuous,
programming is complete and your
device should activate when the
garage door opener button is pressed
and held for approximately 1 to 2
seconds and then released.
• If the indicator lamp blinks rapidly for
two seconds and then turns a
continuous light, proceed with the
following instructions for
Programming rolling code device
equipment.

Hide quick links:

Advertisement

Table of Contents
loading

Related Products for Fisker Karma 2012

This manual is also suitable for:

Karma

Table of Contents