Zone2 Setup - Marantz SR5009 Owner's Manual

Contents Connections

ZONE2 Setup

Configure the settings for audio playback on ZONE2.
Values set for "Volume Limit" and "Power On Volume" are displayed according to the
setting specified for the volume "Scale". (v p. 149)
o Lch Level
Adjust the left channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Rch Level
Adjust the right channel output level.
-12 dB – +12 dB (Default : 0 dB)
o Volume Level
Set the volume output level.
Variable
Volume can be adjusted.
(Default):
Volume is fixed at the desired level. The
1 – 98
volume cannot be adjusting using the remote
(–79.5 dB – 18.0 dB):
control unit.
Front panel Display
Playback Settings
o Volume Limit
Make a setting for maximum volume.
60 (-20 dB) / 70 (-10 dB) / 80 (0 dB)
(Default : 70 (-10 dB))
Off:
This can be set when "Volume Level" is set to "Variable". (v p. 198)
o Power On Volume
Define the volume setting that is active when the power is turned on.
Last
(Default):
Mute:
1 – 98
(–79.5 dB – 18.0 dB):
This can be set when "Volume Level" is set to "Variable". (v p. 198)
Rear panel 198
Tips
Do not set a maximum volume.
Use the memorized setting from the last
session.
Always use the muting on condition.
The volume is adjusted to the set level.
Remote Index
Appendix