Inspection And Testing; Installation - Jacuzzi PURE AIR BATH SERIES Installation And Operation Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

Inspection and Testing

Visual Inspection
Remove the bathtub from the shipping carton. Be careful not to scratch the surface of the bathtub on exposed
1
staples. Remove the staples or fold them into the carton. Retain the carton until satisfactory inspection of the
product has been made. Do not lift the bathtub by the plumbing at any time; handle by the shell only.
Inspect the shell and bathtub components. Should inspection reveal any damage or defect in the finish or visible
2
damage to any components, do not install the bathtub. Damage or defect to the finish claimed after the bathtub
is installed is excluded from the warranty. Jacuzzi Luxury Bath's responsibility for shipping damage ceases upon
delivery of the products in good order to the carrier.
Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations, refer to the
3
published warranty information packed with the product or in the back of this manual.
Bathtub Water and Operational Test
All bathtub units are factory tested for proper operation and watertight connections prior to shipping. However, the unit
must be retested by the installer prior to installation. Jacuzzi Luxury Bath is not responsible for any defect that could
have been discovered, repaired, or avoided by following this inspection and testing procedure:
Place the bathtub on a level surface, near appropriate electrical supply, water supply, and water drainage. A
1
driveway is a suitable choice.
Seal the drain with tape or a stopper and fill the bathtub to 2˝ (50mm) above the highest air hole.
2
Allow bathtub to stand for 5 minutes.
3
Plug in blower and turn unit on. Confirm that all features function as described in the Operation section of this
4
manual. Do not install the bathtub if bathtub fails to operate as described.
Visually inspect all joints for leaks. Do not install the bathtub if leaks are detected.
5
Return bathtub to box or otherwise protect from damage until time of installation.
6

Installation

A technical specifications manual has been included with your bathtub. The Technical Specifications Manual will
contain pertinent information regarding your Jacuzzi Luxury Bath product. Locate the Technical Specifications Manual
at this time.
Page 6
www.jacuzzi.com
Pure Air
®
Bath
Installation and Operation

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents