Cradlepoint IBR600 Product Manual page 90

COR | USER MANUAL Firmware ver. 5.0.0
CRADLEPOINT
version for REQUESTS / triggered updates).
• Password: RIPv2 allows packets to be authenticated via either an insecure plain text password, included with the
packet, or a more secure MD5 based HMAC (keyed-Hashing for Message AuthentiCation). RIPv1 cannot be
authenticated at all, so when authentication is configured RIP will discard routing updates received via RIPv1
packets.
• Enabled: Click to enable/disable the policy. (Default: enabled.)
Networks: Set the RIP-enabled interfaces by network. RIP is
enabled on the interfaces that have addresses within the network
range.
Neighbors: When a neighbor doesn't understand multicast, this
command is used to specify neighbors. In some cases, not all
routers will be able to understand multicasting, where packets are
sent to a network or a group of addresses. In a situation where a
neighbor cannot process multicast packets, it is necessary to
establish a direct link between routers. The neighbor command
allows the network administrator to specify a router as a RIP neighbor. The no neighbor a.b.c.d command will disable the
RIP neighbor. Assign a neighbor by inputting an IP address.
Redistribute Routes: Redistribute routes of the specified protocol or
kind into BGP, with the metric type and metric set (if specified), filtering
the routes using the given route map (if specified). Redistributed routes
may also be filtered with distribute lists.
• Type: The type is the source of the route. Select from: Main,
Connected, Static, RIP, OSPF.
• Metric: Numerical priority of the route.
• Route Map: Route maps provide a means to filter and/or apply
actions to routes, allowing policies to be applied to routes.
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 87