Advertisement
LEDJ Spectra Batten
Over view
Over view:
Operation:
After the power is switched on, Press the "MODE" button to activate the main menu:
Built-in programmes mode, Auto run mode, DMX mode, Slave mode or Sound-active mode.
"SETUP" button is to change the parameter of the current mode.
"UP" button is to increase the value of the current setting.
"DOWN" button is to decrease the value of the current setting.
Built-in programmes: Runs one of the13 built-in programmes.
Auto run: Runs the built-in programmes in a continuous loop.
DMX mode: The unit can be controlled by any universal DMX controller.
Slave mode: The battens in this mode will be synchronously run with a batten
set to master mode.
Sound activated mode: Runs sound activated using the built-in microphone
Built-in programmes mode:
With the LEDJ indoor Spectra Batten, yon can select 13 different Programmes. Press the "SETUP"
and "UP" and "DOWN" buttons to select the programmes (from PG00 to PG12) and select the
PG- -
desired programme value. When the LCD display shows
(except PG00), press the "SETUP"
SP.99
button for the first time, and it will show
, you can now select the running speed by using
the "UP" and "DOWN" buttons; then press the "SETUP" button for the second time, and it will show
FS.00
, you can now select your desired flash frequency by using the "UP" and "DOWN"
PG.00
C-.-1
, press the "SETUP" button for the first time, it will show
buttons. But when in
,
Advertisement
