What is what?
WHA T IS WHAT?
Starting and stopping
1151020-95 Rev. 2 2008-03-10
Note the following before
Please read the operator's manual carefully.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
This engine label certiﬁes that the product is certiﬁed in
accordance with American exhaust emissions
requirements EPA Ph II and Californian exhaust and
evaporative emissions requirements CARB Tier III. The
Emissions Compliance Period referred to on the
emissions compliance label indicates the number of
operating hours for which the engine has shown to meet
Federal and Californian emission requirements. Category
C = 50 hours, B = 125 hours, and A = 300 hours.
The engine exhaust from this product
contains chemical known to the State
of California to cause cancer, birth
defects or other reproductive harm.
WARNING! Long-term exposure to noise
can result in permanent hearing
impairment. So always use approved
WARNING! Under no circumstances may
the design of the machine be modiﬁed
without the permission of the
manufacturer. Always use genuine
modiﬁcations and/or accessories can
result in serious personal injury or the
death of the operator or others.
Your warranty may not cover damage or
liability caused by the use of non-
authorized accessories or replacement
WARNING! An edger can be a dangerous
tool if used incorrectly or carelessly, and
can cause serious or fatal injury to the
operator or others. It is extremely
important that you read and understand
the contents of this operator's manual.