Fitting the loop handle
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
•
Fit the bolt, securing plate and wing nut as shown in
the diagram.
•
Tighten the wing nut.
Assembling the angle gear
(326Ex)
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
•
Position the angle gear so that its slot is aligned with
the line on the supporting tube.
•
Firmly tighten the screw.
12 – English
ASSEMBLY
Assembling the angle gear
(326ES)
•
Assemble the angle gear back on the suppporting
tube. Turn the blade so that the drive shaft engages in
the angle gear.
•
Tighten the two screws.
1151020-95 Rev. 2 2008-03-10