Functional Description - Delta ShopMaster MS265 Instruction Manual

10" compound power miter saw

Hide thumbs

Table Of Contents

Table of Contents

EXTENSION CORDS

Use proper extension cords. Make sure

your extension cord is in good condition and is a 3-wire

extension cord which has a 3-prong grounding type

plug and matching receptacle which will accept the

machine's plug. When using an extension cord, be sure

to use one heavy enough to carry the current of the

machine. An undersized cord will cause a drop in line

voltage, resulting in loss of power and overheating. The

chart at right shows the correct gauge to use

depending on the cord length. If in doubt, use the next

heavier gauge. The smaller the gauge number, the

heavier the cord.

FOREWORD

Delta ShopMaster Model MS265 is a 10" Compound Power Miter Saw designed to cut wood, plastic, and aluminum.

Compound angle and bevel cutting are easy and accurate. It can crosscut up to 5-5/8" x 2-3/4", miter at 45° both left

and right 4" x 2-3/4", bevel at 45° left 5-5/8" x 1-5/8", and compound 45° x 45°, 4" x 1-5/8". It has positive miter at 0°,

15°, 22.5°, 31.62°, and 45° both left and right, and bevel stops at 0° and 45° degrees adjustable.

NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE

CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED

IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE

ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO

ILLUSTRATE TECHNIQUE ONLY.

UNPACKING AND CLEANING

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from

all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,

gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household

floor paste wax.