Installation Of The Firebricks - J. A. Roby ATF727 Owner's Manual

INSTALLATION OF THE FIREBRICKS

To begin with, you must consider that the screw which will fix the bottom bricks and the
one which will fix the lateral bricks are partially screwed and that the stainless pipes (4)
are installed. There are three (3) pipes model #1 and 1 pipe model #2.
Stages :
1. Install the first row of bricks (stand up) on the lateral sides (5 on each side).
2. After that, install the ten bricks at the bottom of the appliance. Take care to push
them against the bottom wall.
3. Install the two small bricks on each side.
4. Then, install the four bricks in the stand up position and press them against the
bottom wall (Do not screw immediately).
5. Install the bricks on each lateral sides (3 in the larger position as illustrated) and
install the two bricks on the bottom wall.
6. Screw all the screws but don't tighten too much in order to avoid the blow up of
the bricks.
7. Place the bricks support on the top and be sure that it is centered.
8. Install the eight top bricks (over the bricks support).
* Be sure that they are centered and place them against each other. (Pass the
bricks by the chimney hole).
13