Set Up; Calibration - promethean ActivBoard 500 PRO User Manual

Set Up

DPS-90GB A or 153413

Calibration

is section describes how you can check if your
ActivBoard needs calibrating.
When using an ActivBoard, you may need to re-
calibrate if the whiteboard or projector have been
moved for any reason. Calibration aligns the tip of the
ActivPen to the cursor on the screen.
does your activboard need
calibrating?
With both the ActivBoard and the computer
switched on, hold the ActivPen lightly on the
ActivBoard, without pushing in the ActivPen nib.
cursor, on the ActivBoard, should line up with the tip
of the ActivPen. If it does not, you need to calibrate
the ActivBoard.
three ways to calibrate your
activboard
How you calibrate the ActivBoard depends on the
type of ActivBoard.
method
Hover the ActivPen over the Calibration light in the
top-left corner of the ActivBoard for a few seconds.
Follow the on-screen instructions.
42-50kg
98-112lb
method
Right-click on the ActivManager icon
bottom right-hand corner of the display.
Select Calibrate.
Follow the on-screen instructions.
Check that the tip of your ActivPen lines up with the
cursor on the ActivBoard. If it does not, try Method 3.
method
On your computer:
e Right-click on the ActivManager icon
bottom right-hand corner of the screen.
Select Calibrate.
Once the calibration program starts, move to the
board and follow the on-screen instructions.
After calibrating, check that the tip of your ActivPen
lines up with the cursor on the ActivBoard. If it does
not, reset the board by switching it off for thirty
seconds.
en switch it on and try calibrating again, or contact
technical support.
DPS-90GB A or 153413
in the
in the
5