NS-SB314 Soundbar Home Theater Speaker System with Bluetooth
Remote control
#
Component
1
2
SOURCE buttons
3
DSP buttons
4
5
VOL +/– buttons
6
BASS button
Using the remote control
1 Remove the plastic tab from the battery
compartment before using the remote control
for the first time.
2 Point the remote control directly at the IR sensor
on the front of the soundbar. You must be
within approximately 23 ft. (7 m) of the
soundbar.
Description
(Power) button
Press to turn on the soundbar. Press again to put the soundbar into standby mode.
Press to select the sound source for your soundbar:
• Source 1 - Optical
• Source 2 - AUX IN
• Source 3 - RCA
•
Press to select the Digital Signal Processor (DSP) sound mode:
• Standard
• Theater
• News
The corresponding indicator on the soundbar top panel lights to indicate the sound mode
selected.
(Mute) button
Press to mute the sound from the soundbar. Press again to restore the sound.
Press to increase or decrease the volume of the soundbar.
Press to activate the bass frequency enhancement.
IR Sensor
www.insigniaproducts.com
- Bluetooth
Cautions
•
Do not spill water or any liquid on the remote
control.
•
Do not place the remote control on a wet
surface.
•
Do not place the remote control in direct
sunlight or near sources of excessive heat.
•
If you are not going to use the remote control
for a long time, remove the battery to avoid any
damage that may be caused by leakage and
corrosion.
5