Advertisement
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
NOTE: The Brick Splitter comes completely assembled, but for additional informa-
tion regarding the parts listed in the following pages, refer to the Assembly Diagram
on page 7 of this manual.
noTe: be sure the brick splitter is set on a flat level surface that is capable
of supporting weight of the brick splitter and the bricks being split before
adjusting or using.
see the assembly diagram on page 5 as a reference when completing the
steps below.
1.
Set the blade (13), which is attached to the Blade Guard (9) at the correct height
for the brick you will be splitting. This is done by first, measuring the brick, then
adjusting the Blade (13) so it is as close to the top of the brick as possible without
touching the brick surface. You want to be able to smoothly move bricks in and out
of the the Brick Splitter opening. The correct way to adjust the brick splitter is
with the handle (1) in the full down position.
2.
The Blade (13) is adjusted in the front by twisting the Thread Rod (5) either clockwise
into the Support Frame (4) which will lower the front section, or counterclockwise
which will raise the front section. See figure 1.
for technical questions, please call 1-800-444-3353.
SKU 95916
unpacking
asseMbly insTrucTions
operaTion insTrucTions
figure 1
5
1
4
Page 4
Advertisement
