Table of Contents
Advertisement
Appendix C: PRINTER STATUS
LCD display
PAUSE
MEDIA OUT
RIBBON OUT
SERIAL IO ERROR
CUTTER FAILED
MEMORY FULL
HEAD OPEN
P. SENSOR O.R.
Fastmark 6000 Series
Blinking LED
Description
READY
The printer is in a pause state. Press
PAUSE or CANCEL to return to normal
state.
MEDIA
The media is uninstalled or used up. Load
new media to the printer.
READY
RIBBON
The ribbon is uninstalled or end-of-ribbon
occurred. Load new ribbon to the printer.
READY
If using Direct Thermal media verify that
Switch 1 is off.
READY
The format or baud rate of the RS-232
communication may be incorrect. Verify
host and switches 6 to 8.
READY
The cutter can not cut off the media, check
the media and cutter.
READY
The printer buffer is full. Possibly caused
by the loaded soft fonts, graphics or forms.
Check the format of these data.
READY
The printhead latch is not closed. To print
the label the head latch must be closed.
READY
The media sensor is out of range during
calibration. Make sure the media is
installed and the label sensor is put under
the media.
User's Guide
75
Advertisement
Table of Contents
