NEC IP3NA-12TXHBT User Manual page 47

3
On the Bluetooth
[1. -- Bluetooth Headset --] in this order and select a Bluetooth
headset to pair with from a list of Bluetooth
4
Select [1. <Paired Headset>] > [2. Connect] > [2. Enable] in the
pairing screen in this order and press the OK key.
Pairing between the Bluetooth
completed.
After pairing, be sure to configure the cradle connection with the Bluetooth
Caution
headset in Step 4 to enable it. If connection setting is not done, the Bluetooth
headset cannot be used.
Before pairing your Bluetooth
cancel the connection (or standby mode) with the Bluetooth
connect the Bluetooth
Do not connect the Bluetooth
to other Bluetooth
terminating calls.
To unpair a paired Bluetooth
Select [1. Delete] in the Bluetooth
screen. Press the OK key to unpair the paired Bluetooth
®
screen, select [1. Pairing Mode] > [1. Pairing] >
It takes approximately one
minute for locating.
®
headset and the Bluetooth
® headset in use with the Bluetooth
headset to the Bluetooth
®
® headset that is paired with the Bluetooth
® devices. Doing so may disable operations for originating and
®
headset
®
Headset screen in Step 4 above to switch to a Delete
Connecting a Headset
®
devices located.
®
® terminal,
device in use. Then
®
terminal and use it.
®
®
headset.
®
terminal is
®
®
® terminal
1 - 37