Yamaha CS50 Service Manual page 193

• Set the main switch to "ON".
• Measure the voltage (DC 12 V) of red/yellow
on the multi-function meter coupler (wire
harness side).
• Is the voltage within specification?
YES
The wiring circuit
from the main
switch to the multi-
function meter bulb
socket coupler (wire
harness side) is
faulty, repair it.
2. Speed sensor
• Connect the pocket tester (DC 20 V) to the
speed sensor coupler (wire harness side) as
shown.
Positive tester probe
Negative tester probe
L B R
• Set the main switch to "ON".
• Elevate the front wheel and slowly rotate it.
• Measure the voltage (DC 12 V) of red/yellow
and black/yellow. With each full rotation of
the front wheel, the voltage reading should
cycle from 0 V to 5 ~ 11V to 0 V to 5 ~ 11V.
• Does the voltage reading cycle correctly?
YES
This circuit is OK.
SIGNALING SYSTEM
NO
blue/green
black/yellow
L B R
G / Y /
Y /
NO
Replace the speed
sensor.
EAS00802
7. The water temperature warning light fails to
come on (CS50Z only).
1. Water temperature warning light bulb and
socket
• Check the water temperature warning light
bulb and socket for continuity.
Refer to "CHECKING THE BULBS AND
BULB SOCKETS"
• Are the water temperature warning light
bulb and socket OK?
YES
EAS00811
2. Thermo switch
• Remove the thermo switch from the cylin-
der head.
• Connect the pocket tester (Ω x 1) to the
thermo switch
• Immerse the thermo switch in a container
filled with coolant.
• Place a thermometer in the coolant.
• Slowly heat the coolant, then let it cool
down to the specified temperature.
• Check the thermo switch for continuity at
the temperatures indicated below.
Coolant temperature
Test step
1
2 More than 120
3* 120
4* Less than 113
Steps 1 & 2: Heating phase
Steps 3* & 4*: Cooling phase
8-34
ELEC
NO
Replace the water
temperature war-
ning light bulb,
socket or both.
as shown.
Thermo switch
0 ~ 120 3°C
3°C
3°C to 113 3°C
3°C
Conti-
nuity
NO
YES
YES
NO