Change Language - Mitsubishi Electric Ecodan PUHZ-W50VHA-BS Homeowner's Manual

Change Language

The initial language setting is English. If you require to change this follow the 4 steps below. The instructions in this guide
use English for the annotated displays, whatever language is selected the combination of buttons will not alter.
1 Normal Display
D E
2 Change Language
G
G
Language
3 Language
English (GB)
Deutsch (D)
G
Language
Spräk VAL
D E
4
Normal Display
Setting day of the week and time
Unlike having a default language, the day and time will run from the day the system is switched on. To change these settings
please following instructions.
1
Normal Display
2
Mon Tue
3
Time
As you hold the C button down, the time (displayed at 1) will increment first in one minute intervals, then in ten minute
intervals, and then in one hour intervals. This works in either direction.
Note:
"PLEASE WAIT" message
This message is displayed for approximately 3 minutes when power is supplied to the FTC unit or when the unit is recov-
ering from a power failure
"NOT AVAILABLE" message
This message is displayed if a button is pressed to operate a function that the FTC unit does not have, or a function that is
not available due to the setting.
Throughout this guide the buttons on the controller are referenced by letters and displays by numbers ; this key can be found on page 10
G G
Language
Espanol(E)
G
G
Language Language
French(F) Italiano(I)
C
Wed Thu Fri
Step 3:
Press either of the C buttons
as necessary to set the time.
Step 1:
Hold down buttons D and E for 2 seconds.
This activates the controller
Step 2:
Press button G. To scroll through the lan-
guages
Language
Step 3:
Pycck(RU)
For each press of button G will move
G
through the 7 available languages. Leave on
desired language to proceed.
Step 4:
Hold down buttons D and E for 2 seconds.
To return to original screen.
Step 1:
Press either of the C buttons
to start
Step 2:
Press button D to advance
Sat Sun
through each day. Once on
current day press C to set
time.
To finish:
Press button E when settings
are complete.
11