Sanyo PLC-XK2200 Owner's Manual page 9

When the projector is controlled by a
computer, connect to this jack with serial
control cable.
Connect output signal from a computer,
component video output, RGB scart 21-
pin video output or S-video output to this
terminal. (pp.14-16).
– Connect analog RGB output signal from a
computer to this terminal (p.14).
– This terminal can be used to output the
incoming analog RGB and Component
signal from COMPUTER IN 1 /S-VIDEO
IN /COMPONENT IN terminal to the other
monitor (pp.14,16).
Connect the composite video output signal
to this jack (p.15).
Part Names and Functions
(MIC)-
Connect the LAN cable (refer to the owner's
manual of "Network Set-up and Operation").
Connect an external audio amplifier to this
jack (pp.14-16).
This terminal outputs sound from AUDIO IN
terminal.
Connect the audio output signal from
computer or video equipment connected to
and to this jack. Or connect the MIC to
this jack. (pp.14-16).
Connect the audio output signal from video
equipment connected to
a mono audio signal (a single audio jack),
connect it to L(MONO) jack. (p.15).
When using AUDIO IN(PC/MIC)
terminal as MIC input, these terminals can
be used for PC audio input.
to this jack. For
9