Husqvarna FS 305 Operator's Manual page 21

• To change the oil, remove the disk, lower
the saw to the lowest position and then
place the tray by the drain outlet (L) [
4].
FIG.
AIR FILTER
• Read engine owners manual for
maintenance intervals. For extremely
dusty conditions you may have to clean
the air filter element 2 to 3 times a day.
• Replace any damaged filters or gaskets.
11 Engine belt tension
It may be necessary after using a few times
to retension the belts, without over-
tightening them. To do this :
loosen the 2 nuts (S) fixing the motor to
•
the chassis, without removing them
[ 5];
SEE FIG.
tighten the tensioning nuts (N), these
•
screws pull the motor up.
.
at normal tension, tighten the motor
•
fixing nuts (S).
12 Important advice
SEE
• Periodically, tighten the nuts and bolts
and particularly after the first few hours of
use.
• Check belt tensions, tighten them without
overdoing it.
• When garaged, it is recommended the
disc be removed and suitably stored.
• Make sure the disc is correctly tightened.
• Make sure the disc supports surfaces, the
adaptor plates and the spindle are kept
clean.
13 Repairs
We carry out all repairs in the
shortest possible time and at the
most economical prices (see
overleaf for our address).
14 Spare parts
For quick supply of spare parts and to
avoid any lost time it is essential to quote
the data on the manufacturer's plate fixed
to the machine and the part number of the
part to be replaced with every order.
00000000 (0)
Item number
See exploded view
15 Scrapping
• Main materials :
Motor : Aluminium (AL), Steel (AC),
•
Motor : Copper (CU), Polyamide (PA)
Machine : Steel sheet (AC),
•
Machine : Cast iron (FT)
Machine : Aluminium (AL)
The instructions for use and spare parts
found in this document are for information
only and are not binding.
As part of our product quality improvement
policy, we reserve the right to make any
and all technical modifications without prior
notice.
Quantity
12