Before Requesting Service - Panasonic NN-SD691S Operation And Cooking Manual

Before Requesting Service

The oven causes
interference with my TV.
Steam accumulates
on the oven door and warm
air comes from the oven
vents.
I accidentally ran my
microwave oven without
any food in it.
PROBLEM
Oven will not turn on.
Oven will not start cooking.
When the oven is turning on,
there is noise coming from
Glass Tray.
The word "Child" appears in
the Display Window.
"H97", "H98" or "H00"
appears in the display
window.
If it seems there is a problem with the oven, contact an authorized Service Centre.
THESE THINGS ARE NORMAL
Some radio and TV interference might occur when you cook with the
microwave oven. This interference is similar to the interference caused
by small appliances such as mixers, vacuums, hair dryers, etc. It does
not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food. Most
of the steam and warm air are removed from the oven by the air which
circulates in the oven cavity. However, some steam will condense on
cooler surfaces such as the oven door. This is normal.
Running the oven empty for a short time will not damage the oven.
However, we do not recommend this.
POSSIBLE CAUSE
The oven is not plugged in
securely.
Circuit breaker or fuse is tripped
or blown.
There is a problem with the
outlet.
The door is not closed
completely.
Start Pad was not pressed after
programming
Another program has already
been entered into the oven.
The program has not been
entered correctly.
Stop/Reset Pad has been
pressed accidentally.
The roller ring and oven bottom
are dirty.
The Child Lock was activated
by pressing Start Pad 3 times.
The display indicates a problem
with microwave generation
system.
– 20 –
REMEDY
Remove plug from outlet, wait 10
seconds and re-insert.
Reset circuit breaker or replace
fuse.
Plug another appliance into the
outlet to check if the outlet is
working.
Close the oven door securely.
Press Start Pad.
Press Stop/Reset Pad to cancel
the previous program and
program again.
Program again according to the
Operating Instructions.
Program oven again.
Clean these parts according
to care of your oven (See next
page).
Deactivate Lock by pressing
Stop/Reset Pad 3 times.
Contact the specifi ed service
centre.