System Configuration - Stereo Mode - Russound X75 Installation Manual

SYSTEM CONFIGURATION - STEREO MODE

The X75 has dual source capability. If two sources are used, connect the source
you want to listen to most of the time to the Line 2 (secondary) input and the
source you listen to less constantly to the Line 1 (primary) input.
Whenever the Line 1 (primary) source becomes active, that signal will take
priority over the distributed audio signal on the Line 2 (secondary) input. The
signal remains active but not heard on the Line 2 input, and once the Line 1
audio signal is muted or turned off, the X75 will automatically switch back to
the Line 2 (secondary) audio signal.
Stereo Mode
1. Unplug the X75.
2. Set the Stereo/Bridge switch to Stereo.
3. Connect the audio line output from a stereo preamplifier or source to the
left and right Line 2 input jacks of the X75 (for secondary source).
4. Connect the audio line output from the primary source to the Line 1 input
jacks in the same manner.
5. Connect your speakers to the terminals, observing proper polarity.
6. Restore power to the amplifier. Use the front panel knobs for Balance and
Volume adjustments.
6 Russound X75 Installation Manual