Yamaha YSP-4000 Owner's Manual page 46

AUTO SETUP (IntelliBeam)
8
Check that the following screen is displayed
on your
TV.
The results of the AUTO SETUP procedure are
displayed on your TV.
Example 1
9
Press ENTER to confirm the results or press
RETURN to cancel the results.
The following screen is displayed for two seconds
and then disappears from your TV.
-"·1' -r-I'L'"
;,HU
J)
k:~;l
J I
t'lEflSURH1E~lT CO~lPLETE ~I-
Flashes
BEflM MODE :5 BEflM
SUB~JOOFER : tlOT flPPL I CflBLE
[E~lTER] : S.a~Je set-uP,
[RETUR~l]:
[lO
not save set-up,
flUTO SETUP CONPLETE
Please rep)o~!e the tHC fror'l
the YSP and the listening
position.
Example 2
,-I
11' 1 1
~'~'-l'LT
::HIj'!1
r.:t
::u
t'lEflSURE~lEtH Cot'lPLETE ~ -
Flashes
ENVIROtlMENT CHECK[FflILEDJ
BEAt'l t'10DE :
5
BEAt'l
SUBI,JOOFER : \'ES
[HlTERJ: Save set-up,
[RETURNJ:Do not save set-up.
,',
~'il~
• If "ENVIRONMENT CHECK [FAILED)" is
displayed. we recommend running the AUTO SETUP
procedure again. For details, see step 9.
• If "SUBWOOFER : NOT APPLICABLE" is displayed
even though a subwoofer is connected to this unit,
increase the volume level of the subwoofer and run the
AUTO SETUP procedure again.
• Depending on the environment of your listening room,
the beam angle of front left and right, and surround left
and right may be set to the same value even if
"5 BEAM" is displayed as a result.
42
En
If "ENVIRONMENT CHECK [FAILED]" is displayed in
step 8, the following screen is displayed after pressing
ENTER. In this case, see ERROR E-\ in "Error messages
for AUTO SETUP" on page 43. Press ENTER to exit
AUTO SETUP and then run the procedure again from
step 3.
AUTO SETUP Cot'lPLETE
',lour YSP I.lni t Pla\i not be set
IJP correctl'~,
We recoMMend \iOU tr\i again.
Ple.~se
press [ENTERJ ke\i to
exi to
10
Disconnect the IntelliBeam microphone from
the INTELLIBEAM MIC jack on the front
panel.
'"
~'il~
If you want to save and load settings. see "Using the system
memory" on page 44.