Remote Control - Yamaha YSP-4000 Owner's Manual

[fem
This section describes the functions of the remote control
used to control this unit. Some buttons marked with an
asterisk
(*)
share the common functions between the YSP
and TV/AV operation modes
(@).
,0,
:<i>~
You can also control other components using the remote control
once you set the appropriate remote control codes. See
"Controlling other components" on page 104 for details.
CDl------,
,....----@
_ - L - - - - J . . _
*
Controls and functions
CD
Infrared window
Outputs infrared control signals. Aim this window at the
component you want to operate.
®
STANDBY/ON
Sets this system to the standby mode (see page 33).
@ Transmission indicator
Lights up when infrared control signals are being output.
@) Input selector buttons
Use to select an input source (DVD, AUX1, AUX2,
AUX3, STB, TV, or FM).
®
VOL MODE
Turns on or off the volume modes (see page 71).
®
AUTO SETUP
Enters the AUTO SETUP menu (see page 37).
(J) CINEMA DSP program buttons
Select the CINEMA DSP programs (see page 65).
®
ENHANCER
Turns on or off the Music Enhancer (see page 70).
®
Cursor buttons
6. / "V /
<1/
~, ENTER
Select and adjust SET MENU items.
@) DISPLAY
Displays information on the selected input signal.
@ VOLUME+/-
Increases or decreases the volume level of this unit (see
page 49).
@ MUTE
Mutes the sound. Press again to restore the audio output to
the previous volume level (see page 49).
@
TV INPUT
Toggles between the input sources on the TV (see
page 104).
@ CH LEVEL
Adjusts the volume level of each channel (see page 91).
@
TEST
Outputs a test tone when adjusting the output level of each
channel (see page 90).
11
En
•