Before You Begin; Location Of Controls - Lopi Sturbridge Owner's Manual

Before You Begin

Warning: Read this entire manual before you use your new stove (especially the section "Safety
Precautions" on pages 4 & 5). Failure to follow the instructions may result in property
damage, bodily injury, or even death.
Warning: Do not operate appliance with the glass front removed, cracked or broken. Replacement of
the glass should be done by a licensed or qualified service person.
Location of Controls - See explanation below
Gas
Control
Valve
On/Off Switch
Optional Blower Control
Gas Control Knob
Flame Adjust Knob This knob controls the flame height from low ("LO") to high ("HI"). The
Pilot Igniter
• If using a remote control or thermostat, the On/Off Switch must be left "OFF". Turning the On/Off
Switch "ON" will keep the stove on always.
Travis Industries
Operation
Swing the control cover
down to access the gas control
valve and pilot igniter.
Gas Control Knob
This control is used to turn the flame on and off.
This knob controls the speed of the internal convection blower that
pushes heated air into the room.
This knob controls gas to the stove and pilot. There are three positions: ON,
OFF, and PILOT. The indicator line is to the left of the knob.
indicator line is above the knob.
The pilot igniter is used only to start the pilot. When pressed, it sends an
electrical charge to the pilot assembly. This creates a blue spark directly next
to the pilot, igniting the pilot flame.
1 0 0 - 0 1 1 4 2
ON/OFF Switch
Optional Blower Control
An instruction card for
operating the fireplace is
attached to the inside of the
fireplace here. Replace it for
easy reference.
IGNITER
Flame Adjust Knob
2 1
The Pilot Flame
can be found below
the back log.
Pilot Igniter
4 0 2 0 9 1 7