Adjust Menu - Tekmar 527 Installation & Operation Manual

Adjust Menu (1 of 2) *for installer use only
Press
+ +
Together
Display
Continued on next page.
© 2009 D 527 - 06/09
528 Thermostat
These settings are intended for use by the installer only and are
not required for use by average users of the thermostat.
• Press and release the Mode,
• Press and release the Mode button to go to the next setting.
• Once all settings are complete, wait 20 seconds for the thermostat
to return to normal operation.
Range
40 to 85°F
(4.5 to 29.5°C)
SET ROOM HEAT
Default = 70°F
Set the room heating temperature while in the
(21.0°C)
40 to 85°F
(4.5 to 29.5°C)
SET ROOM HEAT
Default = 65°F
Set the room heating temperature while in the
(18.5°C)
40 to 85°F
(4.5 to 29.5°C) SET ROOM HEAT AWAY
Default = 62°F Set the room heating temperature while in the Away scene.
(16.5°C)
SET FLOOR MINIMUM
Set the floor minimum temperature while in the
floor minimum heats the floor even when the room temperature
OFF, 40 to 85°F
is satisfied.
(OFF, 4.5 to
The measured floor temperature is shown in the upper right hand
29.5°C)
corner of the display.
Default = 72°F
Available when:
(22.0°C)
• Room Sensor setting in the Adjust menu is set to On AND
• A slab sensor is installed on the auxiliary sensor input AND
• Switch setting 4 is set to Floor (On position).
SET FLOOR MINIMUM
Set the floor minimum temperature while in the
floor minimum heats the floor even when the room temperature
OFF, 40 to 85°F
is satisfied.
(OFF, 4.5 to
The measured floor temperature is shown in the upper right hand
29.5°C)
corner of the display.
Default = 68°F
Available when:
(20.0°C)
• Room Sensor setting in the Adjust menu is set to On AND
• A slab sensor is installed on the auxiliary sensor input AND
• Switch setting 4 is set to Floor (On position).
FLOOR MAXIMUM
Set the floor maximum temperature in order to protect the floor
40 to 90°F, OFF
covering.
(4.5 to 32.0°C,
Available when:
OFF)
• Room Sensor setting in the Adjust menu is set to On AND
Default = 85°F
(29.5°C) • A slab sensor is installed on the auxiliary sensor input AND
• Switch setting 4 is set to Floor (On position).
12 of 28
, and buttons together.
Description
event.
event.
event. The
event. The