Indicator Lights - Master Spas LSI 557 Owner's Manual

MASTER SPA

Indicator Lights

The top indicator ligh will be lit up if the spa is in its first filter cycle.The next
down will be lit if the spa is in the second filter cycle.The third will be lit when
the panel is locked.The bottom indicator will be lit when the temperature lock is
enabled.
Invert
Press the "Warm" or "Cool" button, followed by the "Jet 3" button to change the
number in the display to read upside down.This feature is not available on the LSI
557 model.
Light (Icon)
Press the "Light" button to turn the spa light on and off. If a LED light system is
installed, press the "Light" button once to start the color cycle, press it again to
stop the cycle, and then again to turn the light off. The light icon stands still
when the LED light is on by itself, and rotates when the color wheel is on.
If either light is left on, it will automatically turn off after 4 hours.The LSI 557
with the LED light option will only continuously change colors when on.
Circ Pump
Your system is equipped with a circ pump, it maybe configured to work in one of
two different ways:
1.) The circ pump operates continuously (24 hours) with the exception of
turning off for 30 minutes at a time when the water temperature reaches
3 F (1.5˚C) above the set temperature (most likely to happen in very
hot climates). Contact your dealer if you would like it to operate this way.
2.) The circ pump stays on continuously, regardless of water temperature.
Note: Standard setting from factory
Preset Filter Cycles
On all systems, the pump and the ozone generator will run during filtration.
At the start of each filter cycle, the lowest speed of pump 2 and pump 3 will run
for 5 minutes.
Secondary Filter Cycle Programming
You are not required to set filter cycles; however, it is an option available to you.
To change the filter cycle settings:
Press "Time" Mode/Prog" "Mode/Prog" "Mode/Prog" within 3 seconds. You
will see the "Program", "Filter 1" and "Start Time" icons appear on the display.
Press "Warm" or "Cool" to choose the filter start time hour. Enter the hour by
pressing "Mode/Prog". Press "Warm" or "Cool" to choose the filter start time
minutes. Each press changes the start time by 5 minutes.
Enter the minutes by pressing "Mode/Prog".
Press "Mode/Prog" to see the "Program", "Filter 1", and "End Time" icons.
Adjust the time as done above.
America's Leader In Luxury
LED Light
36
(cont. next page)
M A S T E R S P A S