Twilight Spa Controls; Led Lights; Freeze Protection; Preset Filter Cycles - Master Spas TWILIGHT series Owner's Manual

TWILIGHT SPA – CONTROLS
TS 6.2 • TS 67.25 • TS 7.2 • TS 7.25 • TS 8.2 TS 8.25 • TS 8.3 TS 8.35 • TS 240
l.e.d. lights
Press the "Light" button to turn the light on and off. If you wish to change the "function" of the
lights, turn the lights off, then on within 5 seconds. If you wish to leave the lights in the same
"function" setting for the next use, turn the lights off and do not turn back on for at least 5 sec-
onds.
mode
Mode is changed by pressing the "Warm" or "Cool" button, then pressing the "Mode" button.
standard mode is programmed to maintain the desired temperature. Note that the last mea-
sured spa temperature displayed is current only when the pump has been running for at least 2
minutes. " " will be displayed momentarily when you switch into Standard Mode.
economy mode heats the spa to the set temperature only during filter cycles. "
play solid when temperature is not current, and will alternate with temperature when tempera-
ture is current.
sleep mode heats the spa to within 20°F/10°C of the set temperature only during filter cycles. "
" will display solid when temperature is not current, and will alternate with temperature
when temperature is current.

preset filter cycles

The first filter cycle begins 6 minutes after the spa is energized. The second filter cycle begins 12
hours later. Filter duration is programmable for 2, 4, 6, 8 hours or for continuous filtration (indicat-
ed by " "). The default filter time is 2 hours. To program, press "Temp" then "Jets." Press
"Temp" to adjust. Press "Jets" to exit programming. At the beginning of each filter cycle the
pump(s) purge for 30 seconds; the pump purges for 5 minutes. The only effect filter duration has
is: 1) During the filter cycle, the low-speed of pump 1 never turns off, and 2) In Economy and
Sleep Modes, heating only occurs during the filter cycle. On spas equipped with 24 hour circulation
pumps the filter cycle is not needed and does not operate.

freeze protection

If the temperature sensors detect a drop to below 44°F/6.7°C within the heater, the pump will
automatically activate to provide freeze protection. The equipment stays on until 4 minutes after
the sensors detect that the spa temperature has risen to 45°F/7.2°C or higher.
DO NOT DIVE. 40
" will dis-