Installation Instructions - Master Spas LSI 557 Owner's Manual

INSTALLATION INSTRUCTIONS

1.) Put spa in final position that allows for access to equipment of spa
components.
2.) Remove front side panel (This is the side where the main topside control
panel is located) so electrical can be hooked up to the spa system pack.
Panels are removed by unscrewing the screws in the corner sections and
then lifting up the panels out of the retaining tracks.
4.) Be sure all pump and heater unions are secure. Each pump has 2 unions and
the heater has 2 unions. A newly delivered spa may have loose unions caused
in transporting the spa. Check that all slice valves are open, in the up
position. Again, the slice valves may become closed during transportation
of the spa.
Be sure outside drain fitting is fully closed.
5.) Fill spa to the "minimum safe water level" sticker.We recommend filling the
spa through the filter area.
6.) Turn the power on to the spa. Spa will go through its priming mode.
This lasts approximately 5 minutes.
7.) Be sure the jets in your spa are opened.
On all Master Spas: The jets open by turning the jet collar clockwise.
On all Down East / Freedom Spas: The jets open by turning the jet
collar counter clockwise.The smaller jets on the Down East line will
open by turning the jet collar clockwise.The smallest jets in the Freedom
line cannot be opened or closed.
Note:The Master Blasters are only turned on/off through the use of the
"Jets 3" button or the divertor valve.
America's Leader In Luxury
Removing of Panels
Slice Valve
and Pump Union
18
M A S T E R S P A S