External Memory (System User Box); External Memory Device; Supported External Memory Devices; Connecting The External Memory Device - Konica Minolta Bizhub 652 User Manual

7
7.17

External Memory (System User Box)

7.17.1

External memory device

Supported external memory devices

Requirements for external memory devices of this machine are as follows.
- USB flash memory device that supports the USB (1.1/2.0) interface
- FAT32-formatted memory device
- Memory capacity of up to 2 GB is recommended.
- The security function has not been added or the security function can be turned off.
Reference
- If the memory capacity exceeds 4 GB, the USB memory may not work when it is connected to this ma-
chine.
- The USB memory cannot be used if it is recognized as multiple drives on the computer.

Connecting the external memory device

0 Use the USB connector on the side that is near the control panel. Do not use the USB connector near
the rear side because it is used for optional devices.
0 Do not disconnect the external memory device while saving a document in the external memory device
or printing a document saved in the external memory device.
0 Do not use the USB device (hard disk or USB hub) other than the USB flash memory device.
0 Do not connect or disconnect the USB memory when the hourglass is being displayed in the control
panel while this machine is active.
0 Do not disconnect the USB memory just after connecting it.
%
Connect the external memory device to the USB connector on the side of this machine.
When the external memory device is connected, an icon appears at the bottom of the screen and the
following screen is displayed. If you will immediately use the external memory, select the intended pur-
pose. When not using the exert memory, select [Close].
7-98
External Memory (System User Box) 7.17
bizhub 652/552