Using The Tmk - Kia Sorento Owner's Manual

8. Button for reducing tyre inflation
pressure
9. Hose to connect compressor and
sealant bottle or compressor and
wheel
Connectors, cable and connection
hose are stored in the compressor
housing.
WARNING
- Expired
sealant
Do not use the tyre sealant after
the sealant has expired (i.e.
pasted the expiration date on
the sealant container). This can
increase the risk of tyre failure.
WARNING
- Sealant
• Keep out of reach of children.
• Avoid contact with eyes.
• Do not swallow.
Strictly follow the
sequence, otherwise the sealant
may escape under high pressure.

Using the TMK

1.Detach the speed restriction label
(0) from the sealant bottle (1), and
place it in a highly visible place
inside the vehicle such as on the
steering wheel to remind the driver
not to drive too fast.
2.Screw connection hose (9) onto
the connector of the sealant bottle.
3.Ensure that button (8) on the com-
pressor is not pressed.
4.Unscrew the valve cap from the
valve of the flat tyre and screw fill-
specified
ing hose (2) of the sealant bottle
onto the valve.
What to do in an emergency
5.Insert the sealant bottle into the
housing (4) of the compressor so
that the bottle is upright.
6.Ensure that the compressor is
switched off, position 0.
7.Plug the compressor power cord
into the vehicle power outlet.
8.With the engine start/stop button
position on or ignition switch posi-
tion on, switch on the compressor
and let it run for approximately 5~7
minutes to fill the sealant up to
proper pressure. (refer to the Tyre
OXM063007
and Wheels, section 8). The infla-
tion pressure of the tyre after filling
is unimportant
checked/corrected later.
Be careful not to overinflate the
tyre and stay away from the tyre
when filling it.
and will be
6 25