Gear Lever; Parking Brake Wire; Transmission Oil Level - Husqvarna Rider Pro 15 Operator's Manual

9. Gear lever

Remove the transmission cover by undoing the two
screws.
Lubricate the joints and bearings on the left side
using an oil can.
Push the rubber protector out of the way and
lubricate the hydrostatic wire using an oil can.
Press the pedal a few times and lubricate again.
Refit the rubber protector.
Refit the transmission cover.

10. Parking brake wire

Remove the transmission cover; see "Gear lever".
Unhook spring (A) from screw (B) if necessary.
Push the rubber protector aside to lubricate the
wire.
Lubricate the wire using an oil can, press the brake
pedal a few times and lubricate again.
Refit spring (A) and the transmission cover.

11. Transmission oil level

1. Check the level of the transmission oil by
looking through the air intake mesh. The oil
level should be between the "MIN" and "MAX"
marks on the oil reservoir at 20°C.
If it is necessary to top up the oil you must
remove the transmission cover first.
2. Unscrew the cap from the oil reservoir and top
up with SAE 10W/30 grade engine oil, class
SF–CC, until the oil level reaches the "MAX"
mark. Screw the cap back onto the oil reservoir
and refit the transmission cover.
46
– English
LUBRICATION
A
B