Husqvarna Rider Pro 15 Operator's Manual page 36

5. Version 2:
Assembly: First fit the lower belt and then the
upper belt.
Ensure the blades are positioned as set out in
the diagram, at 90 degrees to each other,
otherwise the belts must be adjusted. When the
blade bearings are loose the belts can be
moved around to the next tooth.
Tighten the nuts enough so that the bearings
rest against the cutting hood but still can be
moved.
Tension the belt by turning the eccentric adjuster
on top of the cutting hood. Tighten the nut.
Tighten all nuts on the blade bearings.
6. Version 2:
When the belt can be moved 7 mm inwards using
a force of 10 N the belt is adjusted correctly.
7. Version 1 och 2:
Fit the protective cover over the belts and
replace the parallelism arm.
Belt replacement on BioClip 90
The BioClip 90 is driven by a toothed belt that
synchronises rotation of the blades. The belt is
located under the cover of the cutting unit.
When changing the belt on a BioClip 90 follow
steps 1-7 of the above procedure for version 2.
NOTE! BioClip 90 has just 1 belt.
Belt replacement on cutting unit's with side or
rear ejectors
Cutting units with side or rear ejectors are powered
by one V-belt. Proceed as follows to replace the
V-belt:
1. Remove the cutting unit, see page
2. Undo the bolt on the lift strut and the two screws
on the cover. Lift the cover off the cutting unit.
3& Loosen the spring that tensions the V-belt and
pry off the belt.
Simply reverse the procedure to fit the new belt.
MAINTENANCE
IMPORTANT INFORMATION
The blades on a BioClip unit should be
set at 90 degrees to each other. In all
other cases the blades can collide and
cause serious damage to the cutting unit.
33.
35
English –