Table of Contents
Advertisement
GENERALINFORMATIONON
RADIO FREQUENCIES
CAUTION
The radio frequency used by your
remote control can also be used by
other short distance radio
transmissions (e.g. amateur radios,
medical equipment, wireless headphones,
remote controls and alarm systems). If
the frequencies are jammed, you will not
be able to use your remote control. You
can lock and unlock the doors with the
key.
Note: You could unlock the doors if you
press the buttons on the remote control
unintentionally.
The operating range between your
remote control and your vehicle varies
depending on the environment.
PROGRAMMING THE
REMOTE CONTROL
You can programme a maximum of four
remote controls to use with your vehicle
(including any supplied with your vehicle).
Note: Make sure the anti-theft alarm is
deactivated and that all doors are closed.
1. Turn the ignition key from position 0
to position II eight times within 10
seconds. The ignition must end in
position II and remain in this position.
The door locks will cycle to indicate
that it is now possible to programme
new remote controls.
2. Press any button on a new remote
control within 20 seconds of the door
locks cycling. The door locks will cycle
again to indicate that the remote
control has been successfully
programmed.
Keys and remote controls
3. Repeat step 2 for all your remote
controls, including your original remote
control. Each time a new remote
control is successfully programmed,
the programming period starts again
and it is possible to programme a new
remote control for 20 seconds.
4. Turn the ignition to position 0. The
door locks will cycle to indicate that
the remote control programming is
ended. Only the remote controls
which you have just programmed are
now able to lock and unlock your
vehicle.
CHANGING THE REMOTE
CONTROL BATTERY
Make sure that you dispose of
old batteries in an
E107998
environmentally friendly way.
Seek advice from your local authority
regarding recycling.
If the range of the transmitter in the key
decreases gradually, the battery (type 3V
CR 2032) should be replaced.
E68726
•
Carefully separate the transmitter unit
from the key using a flat object (e.g. a
screwdriver) at the recess on the
back.
•
Carefully prise out the battery with the
flat object. Fit the new battery
between the contacts with the + sign
facing downwards. Reassemble the
transmitter unit in reverse order.
23
Advertisement
Table of Contents
