Table of Contents
Advertisement
The points should be followed when using
●
◆ Check the transmitter casing and pushbuttons daily.Should any damage be
found,the unit should be removed from service.
◆ The transmitter voltage should be checked.If the voltage is low(red status
light blinking or completely off),the batteries should be replaced. If the
transmitter is not used for a long time, please take out the batteries and keep it
safe。
◆ The red emergercy stop button should be checked daily to ensure it is in
proper working .If any question, the receiver should be prohitted to use.
◆ Turn the power switch "off" after each use to avoid the mis-operation.
◆ Before starting, please confirm whether the red emergency stop button(EMS)
is turned on.
◆ Do not use the same RF channel and ID code as any other system in use at
the same facility or test at same area.
◆ Never operate a crane or equipment with two transmitters at the same time
with the same RF channel and ID code.
Advertisement
Table of Contents
