Download  Print this page

Service And Adjustments; To Remove/Install Mower - Husqvarna LTH1742T Operator's Manual

Husqvarna ride-on mowers operator's manual
Hide thumbs

Advertisement

Table of Contents

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
Depress brake pedal fully and set parking brake.
Place attachment clutch in "DISENGAGED" position.
Turn ignition key to "STOP" and remove key.
Make sure the blades and all moving parts have completely stopped.
Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with
plug.
TO REMOVE MOWER (See Fig. 21)
Place attachment clutch in "DIS EN GAGED" position.
Lower attachment lift lever to its lowest position.
Remove mower belt from electric clutch pulley (M).
Disconnect front link (E) from mower - remove retainer
spring and washer.
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
CAUTION: After rear lift links are dis-
connected, the attachment lift lever
will be spring loaded. Have a tight grip
on lift lever when changing position of
the lever.
Slide mower out from under right side of tractor.
TO INSTALL MOWER (See Figs. 21-26)
Be sure tractor is on level surface and engage park ing
brake.
Lower attachment lift lever to its lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
Slide mower under tractor until it is centered under
tractor.
B
A
C
D
Fig. 21
20
F
M
E

Advertisement

Table of Contents
loading

  Related Manuals for Husqvarna LTH1742T

This manual is also suitable for:

Lth1742twin