System Initialization - Maserati Quattroporte Automatic 2009 Owner's Manual

M139_UM_usa1.book Page 144 Monday, September 1, 2008 2:39 PM
Rear control panel
The rear passengers can also utilize the
system using the controls on the rear
control panel.
The rear panel is activated by pressing
button 12 REAR, on the front control
panel.
REAR function
Pressing the button 12 REAR (the
relative LED will come on) will result in
the following:
– the controls incorporated in the rear
control panel will be enabled;
4
– the options set from both control
panels will be repeated on the rear
display.
This function is active both in the
MONO and DUAL zone.
Pressing the button 12 REAR once
again (LED on) will disable the controls
on the rear panel (LED off).
144
Air conditioning and heating system

System initialization

Every time the battery is reconnected,
when the vehicle is started, a system
initialization procedure is required.
This is run by activating the
compressor. Both displays
automatically show the passenger
compartment temperature set at
71.6°F (22°C).
The system is set up as follows:
– AUTO (automatic operation, the
words FULL AUTO appear on the
display).
– Compressor enabled (the LED on the
button lights up).
– Defrosting/demisting (MAX DEF)
deactivated (the LED on the button is
switched off).
– Heated rear window deactivated
(the LED on the button is switched
off).
– Recirculation controlled by the
automatic system (if active, 'AQS'
will appear on the display).
– the air ventilation and distribution
are set by the system.
– REAR deactivated (the LED on the
button is switched off).