Table of Contents
Advertisement
M139_UM_usa1.book Page 34 Monday, September 1, 2008 2:39 PM
Fitting the Latch system child
seat in rearward-facing position
To fit the Latch system child seat in a
rearward-facing position, be
particularly careful that the brackets D
are properly inserted in their seatings
F.
The baby is then secured by the child
2
seat's harness G.
G
F
D
F
E
34
Proper transport of children
Fitting the child seat in
frontward-facing position
For installation, proceed as follows:
– make sure that the release lever E is
in the standby position (retracted);
H
E
F
– align the anchoring points F with
the brackets D, then push the seat
until you hear it click into place,
which indicates it is secured
– check for correct locking by trying to
move the child seat with strength;
the safety mechanisms in fact, help
prevent the child seat from being
improperly fitted if only one of the
attachment fittings is locked.
– pass the strap H underneath the rear
headrest and anchor it onto the child
seat backrest and onto the bracket
on the car body.
This way, the child seat is retained not
only by the brackets D but also by the
vehicle seat belt and by the upper strap
H.
In any case, see the instruction booklet
provided with the child seat for fitting
the vehicle belts into the seat correctly.
D
Advertisement
Chapters
Table of Contents
