System Initialization; View Mirror Position (Optional) - Maserati Gransport Owner's Manual

Storing the seat and side rear

view mirror position (optional)

The system allows the user to store and
recall two different positions of the
driver's seat and of the side rear view
mirrors.
Storage is only possible with the
ignition key in the "MAR" position.
Adjust the seat and side rear view
mirror positions, then shift the gear to
reverse and arrange the mirrors once
again so as to find the optimum field
of view for executing maneuvers.
Afterwards, disengage the reverse
4
gear.
Then, simultaneously press button
"M" and button "1" or "2", each one
corresponding to a storable position,
until the double beep is heard for
confirmation.
1
80 Front seats
Storage of the seat position does not
include the lumbar area seat-back
adjustment.
When a new seat position is stored, the
previous one memorized with the
same button is automatically deleted.
To recall one of the positions stored,
with the door open, push the relevant
button "1" or "2" for approximately 3
seconds.
A stored position can also be recalled
with the door closed, keeping the
relevant button pressed until the seat-
locking beep is heard.
WARNING: To stop the seat, press one
of the following pushbuttons "M", "1"
or "2", or one of the adjustment
controls.
WARNING: Malfunctioning of the seat
control unit is indicated by a sequence
of 5 tones emitted when the ignition
key is turned to the STOP position: see
your Authorized Maserati Dealer for
service.
2 M

System initialization

When reconnecting the power supply
after a power cut-off (e.g. the battery
master switch is activated, the fuse
burns out or the battery goes flat),
check that the seats work correctly: if
not, carry out the following
procedures on both seats.
With the ignition key in the STOP
position and the door closed on the
side of the seat concerned, open the
door and start the following procedure
within 5 seconds.
You must then complete it within 10
seconds:
1) forward - STOP
2) backward - STOP
3) forward - STOP
4) backward - STOP
5) tilt the seatback completely and
wait until the seat performs two
complete travels (forward and
backward)
6) return the seatback to the normal
position.