Maserati Quattroporte Automatic 2009 Owner's Manual page 90

M139_UM_usa1.book Page 90 Monday, September 1, 2008 2:39 PM
Programming
– Press and hold down the keys H and
J;
– after about 20 seconds, the LED K
starts flashing;
– release the keys;
– hold the remote control for the
device to be controlled close to the
HomeLink control panel (12 in);
– simultaneously press and hold down
3
the key of the hand-held remote
control and one of the three
HomeLink keys H, I or J;
– successful programming is signaled
by the LED K flashing faster
– release the keys.
To program the other keys, repeat the
operations skipping the first three
steps.
90
Internal Equipment
Use
– When the signal of the device to be
activated reaches its operating
range, press the dedicated
HomeLink key.
– The LED K remains on while the
signal is being transmitted.
The devices controlled via the
HomeLink function can, in any case,
still be activated from the original
remote controls.
Should the programmed HomeLink
not activate the system to be
controlled, it may be that it is
controlled by a remote control with a
rolling code.
A rolling activation code can be
recognized in the following ways:
– consulting the instruction manual
provided with the device to be
controlled;
– despite the HomeLink programming
procedure having been carried out
correctly, the HomeLink function
does not activate the device;
– holding the dedicated HomeLink key
pressed down, the LED K briefly
flashes fast and then stays on for 2
seconds; this sequence is repeated
for about 20 seconds.
Programming for devices controlled
by rolling code
– Locate the specific setting key by
consulting the user manual of the
system to be controlled. This is
normally located on the motor
which drives the device.
– Press the key and, in normal
conditions, a LED will come on.
WARNING: Normally, after this
operation you have 30 seconds to start
the next one.
– Briefly press the HomeLink key you
have chosen to control the device (H,
I, J).
– Press it a second time; when it is
released the operation should be
completed. For some types of
motors, the key might have to be
pressed a third time.