Refuelling, Fuel/Oil (50 Mini Adventure); Bleeding The Oil System (50 Mini Adventure) - KTM 50 SENIOR ADVENTURE 2006 Owner's Manual

DRIVING INSTRUCTIONS
1
2
B
3
»

Refuelling, fuel/oil (50 Mini Adventure)

FUEL:
Refuel with pure fuel (RON 95) for separate lubrication.
OIL:
The oil tank [1] is mounted on the left side in front of the fuel tank. Here,
the two-stroke oil for separate lubrication of the engine must be filled in. The
oil level can easily be checked through the transparent material of the oil tank.
Engine oil:
A
2-stroke engine oil suitable for separate lubrication
KTM recommends Motorex Cross Power 2T
To open it:
To close it:
Tank volume: 0.3 liters
ONCE THERE IS NO TWO-STROKE OIL IN THE OIL TANK, THE ENGINE IS BOUND
TO BREAK DOWN.
When you refuel, the oil in fresh-oil tank [1] should reach up to the [A] mark.
This amount of oil is enough for a full fuel tank.
The oil pump is mounted on the ignition cover and is powered by the crank-
shaft.

Bleeding the oil system (50 Mini Adventure)

If the oil tank is empty and air has gotten into the oil system, the oil system
must be bled.
3 To bleed, disconnect the oil line [2] from the oil tank and the oil line [3] from
the oil pump. Add oil with a syringe until the bubble-free oil leaks out of hole
[B] on the oil pump. Connect the oil line [2] to the oil tank. Use the syringe
to bleed the oil line [3] to the carburetor and connect to the oil pump.
Afterwards, fill the oil tank with Motorex Cross Power 2T engine oil.
ALWAYS MAKE SURE YOU RUN THE OIL HOSES WITHOUT KINKS.
turn closure cap counterclockwise.
apply closure cap and turn it clockwise.
13