Starting The Engine; Stopping The Engine; Log Splitter Operation - Champion 93020 Owner's Manual & Operating Instructions

30 ton log splitter
Table of Contents

Advertisement

93020
ENGLISH
Log Splitter Location Cont'd.
WARNING
ALWAYS use the log splitter for its intended use . The
log splitter should only be used to split wood logs,
length wise with the grain .
NEVER modify, alter or change the log splitter in
anyway . Modifications will void the warranty .
NEVER attach a rope, cable or other device to the
control lever on the log splitter .
DO NOT modify or change the engine and operating
speeds or pressure settings . These changes can
cause safety issues .
ONLY operate the log splitter in daylight .
NEVER operate, or let anyone else operate, the log
splitter while under the influence of alcohol, drugs,
or medication .
NEVER leave the log splitter unattended while the
engine is running .
DO NOT change the splitting position with the engine
running . Contact with the muffler can cause serious
burns .
Always make sure the beam is in the locked position .
DO NOT let the beam drop as it could crush fingers
or cause damage to the log splitter .

Starting the Engine

1 . Make certain the log splitter is on a flat, level surface .
2 . Flip engine switch to "ON" position (Item A) .
3 . Rotate the fuel valve to the "ON" position (Item B) .
4 . Move the throttle lever (Item C) to the "Fast"
position .
5 . Move the choke lever (Item D) to the "Choke"
position .
6 . Pull the starter cord slowly until resistance is felt and
then pull rapidly . SEE NOTE BELOW.
NOTE
Keep choke lever in "Choke" position for 2 pulls of
the recoil starter . After first pull, move choke lever
to the "Run" position for up to the next 3 pulls of
the recoil starter . Too much choke leads to spark
plug fouling/engine flooding due to the lack of
incoming air . This will cause the engine not to start .
7 . As engine warms up, move the choke lever (Item D)
to "Run . "
Starting the Engine Cont'd.
C
d
NOTE
If the engine starts but does not run make certain
that the log splitter is on a flat, level surface . The
engine is equipped with a low oil sensor that will
prevent the engine from running when the oil level
falls below a critical threshold .
The hydraulic oil needs to be above 10° F (-12° C)
before starting the engine . Cold hydraulic oil can
damage the hydraulic pump .
If outdoor air temperature is below 32° F (0° C)
allow the log splitter to warm up by extending and
returning the wedge several times before splitting
wood .

Stopping the Engine

1 . Turn the engine switch to the "Off" position . (A)
2 . Turn the fuel knob to the "Off" position . (B)

Log Splitter Operation

1 . ALWAYS wear ear and eye protection, protective clothing
and safety gear .
OPERATION
B
A
14
REV 93020-20120419

Advertisement

Table of Contents
loading

Table of Contents