Table of Contents
Advertisement
Converting Oven Burner for Use with Natural Gas
1. Remove broiler drawer.
2. Turn orifice hood counterclockwise (loosen) 2 full
turns.
3. Close air shutter to approximately
4. Replace broiler door.
Converting Oven Thermostat for Use with Natural
Gas
1. Remove 4 burner control knobs from range.
• Exposes 2 screws on burner control panel.
2. Remove 2 screws from burner control panel.
• Panel drops slightly after screws are removed.
3. Grasp bottom of burner control panel, gently lift and
pull out panel until clear of burner valve stems.
• After burner control panel clears valve stems,
continue to roll panel until free from range. Set
aside.
4. Turn the selector screw so the pointer is towards "N".
5. Reverse steps 1-3 to replace control panel and
knobs.
Anti-tip Bracket Installation
To reduce risk of range tipping, secure range with a
properly installed anti-tip bracket.
1
1. Measure 3
/
inches from back wall on right and left
2
side of cabinet cutout. Mark measurements on floor
and draw a straight line connecting marks.
2. Position anti-tip bracket.
• If range is installed beside cabinet(s), place anti-tip
bracket with back edge on line drawn on floor and
side of bracket against cabinet.
• If range is not installed beside cabinet(s), position
range where it will be installed. Draw a line along
side of range on floor from front to back. Remove
range. Place anti-tip bracket with back edge over
line drawn 3
1
/
inches from back wall and side of
2
bracket over line drawn along side of range on floor.
• Anti-tip bracket can be installed on either right or
left side.
or
Anti-tip Bracket Location
3
/
inch.
8
3 1/2"
3. Mark 2 hole locations in anti-tip bracket.
4. Drill 2 holes.
• If drilling into wood, use a
• If drilling into concrete, use a
bit and insert plastic anchors.
5. Secure bracket to floor using screws supplied.
6. After range is slide into position, verify the range
leveling leg has engaged anti-tip bracket.
Verifying anti-tip bracket position
1. After range is in place, open broiler door and remove
broiler rack, pan, and grid.
2. Remove screws in front of broiler area on side of
range that anti-tip bracket is installed.
3. Remove panel and look towards back of oven and
check anti-tip bracket has engaged bracket.
4. Reinstall panel after checking anti-tip bracket.
Remove
Screws
Verify Anti-tip Bracket Position
10
3
/
inch drill bit.
32
3
/
inch masonry drill
16
Remove
Panel
Advertisement
Table of Contents
