Putting A Call On Hold - Sharp FO-P610 Operation Manual

2
If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.
3
If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
•
The above step is necessary if you have set the Fax Signal Receive setting
(see below) to NO.
•
Your fax will not accept the signal to begin reception (5**) if a document is
loaded in its feeder.

Putting a call on hold

To put the other party on hold during a phone conversation, press
When this is done, they cannot hear you. You can put the handset back in the
cradle without breaking the connection. When you are ready to speak with the
other party again, pick up the handset. If you did not put the handset back in
the cradle, press
Beep
Phone goes dead
once and
5
again to resume conversation.
HOLD
Using TEL Mode
twice on the extension
HOLD
.
43